Clean more than just the stain
Make the transition wide enough for the new care treatment to blend visually into the surrounding surface.
Repair less, preserve more
Localised renovation of oiled parquet
A small area of non-film-forming oiled wood can often be refreshed locally, but absorbency and colour must be tested rather than guessed.
10–30 ml/m²thin coat
4–6 hlight use
1test pass
A local repair works best on an evenly oiled, absorbent surface. On a UV-oiled or hardwax-oiled finish, or where there is marked discolouration, the repair edge may remain visible.
Related topicscare for oiled parquet · choosing the right system
Process
From diagnosis to the correct LOBA layer.
Check the absorbency
Confirm the original oil system and use an inconspicuous test area to check whether the selected care product wets the surface evenly and dries correctly.
Apply a minimal amount
Spread the oil in the direction of the wood and remove any excess.
Compare after drying
Assess the colour only after the drying time specified in the TDS; a wet surface always looks darker.
Products for this route
Each product has one clear role.
Cleaning oiled floors
LOBA ParkettSoap
A parquet soap for routine and intensive cleaning of oiled or waxed wood surfaces.
Official LOBA site
Care for oiled floors
LOBA NatureOil
A water-based, solvent-free maintenance oil for whole-floor treatment or localised refreshing.
Official LOBA site
Care for oiled floors
LOBA ParkettOil
A maintenance oil for non-film-forming oiled surfaces and local repairs.
Official LOBA site
Care for oiled floors
LOBA Permanent OilCare
A film-forming maintenance oil that conceals fine scratches and extends the maintenance cycle.
Official LOBA siteSTOP
When should this route not be used?
If the wood is deeply damaged, greasy, contaminated with silicone or otherwise contaminated, a localised oil treatment without preparation may remain sticky or dark.
Next treatment
If surface care is not enough.
Open the directly related technical topic on parketmojster.si.
Questions
All questions →Answers for this procedure.
Will the local patch be completely invisible?
It cannot be guaranteed. The age of the wood, light exposure, previous products and absorbency all affect the colour transition.
Which oil is for factory UV-oiled parquet?
A conventional maintenance oil may not penetrate a non-absorbent UV-oiled surface. After testing, LOBA lists film-forming Permanent OilCare or NatureWax as possible alternatives.
Can I return the furniture after a few hours?
Observe the full-traffic time in the selected product's TDS; for several maintenance oils it is 12 hours under standard conditions.
Don't guess the coating
Send a photo against the light.
The surface type, depth of damage and previous care determine whether the correct route is cleaning, maintenance layer, oil, 2K Contact or sanding.
Start with an assessment